project for a TV stand and storage unit

1 A pupil’s project for a TV stand and storage unit is shown in the photo below. Softwood sides

Shelf

Handle Drawer (a)     The base of the drawer was constructed from a manufactured board and the sides from softwood.      (i)     State the name of a suitable manufactured board for the base of the drawer. 1

(ii)     Describe three benefits of using a manufactured board for the base of the drawer.

(iii)     Describe two sustainability issues that may have made softwood the preferred material for the sides of the TV stand. 2

(b)     The photo below shows the joint in the side of the TV stand used to hold the shelf.

Joint      (i)     Give a reason why the joint shown above is suitable. 1

(ii)     Describe three stages required to manufacture this type of joint using hand tools in a school workshop.

3

(c)     Clear varnish was used as a surface finish for the softwood.     (i)    Describe two benefits of using clear varnish as a surface finish for the softwood. 2

(ii)     Describe two stages in the preparation of the softwood before applying the varnish. 2

(d)     The handle was made from a blank using a centre lathe similar to the one shown in the photo below.

3 Jaw Chuck

Compound Slide Tailstock

Carriage

Cross slide

The handle consists of two parts as shown in the diagram below: Part A Hole Part B

Part B has been knurled.      (i)     Describe the process of knurling on a centre lathe. 3

(ii)     State the functional reason for knurling Part B.

1

Part A was created from a blank roughly sawn from a piece of aluminium bar as shown in the diagram below. Original blank Overall form of Part A

Rough surface     (iii)     State two processes that would be carried out on a centre lathe to manufacture the overall form of Part A from a blank. 2

The drawer of the TV stand contains a thermoplastic facing. The photos below show the piece of plastic cut to size and the rough edge of the plastic after sawing

(e)    Describe four stages required to create a smooth surface finish on the sawn edges of the piece of plastic.

PLACE THIS ORDER OR A SIMILAR ORDER WITH US TODAY AND GET AN AMAZING DISCOUNT 🙂

© 2020 customphdthesis.com. All Rights Reserved. | Disclaimer: for assistance purposes only. These custom papers should be used with proper reference.